Wireless for home and office

(Based on 0 Review)

cAP ac-US

CAD$97.00

Dual-band 2.4 / 5GHz wireless access point for mounting on a ceiling or wall with two Gigabit Ethernet ports (one with PoE output) and 802.11ac support

More details

Product Description


The cAP ac is a very capable and powerful wireless access point that looks beautiful on both walls and ceilings. The concurrent dual band wireless radio supports dual chain 2 GHz 802.11b/g/n and 5 GHz in a/n/ас standards, and will provide coverage in 360 degrees around it.

Even though the radio supports repeater mode, the two Ethernet ports give you the ability to extend your network with cables, even if PoE power is required, since the cAP ac supports 802.3af/at PoE input on the first port, and passive PoE output on the second port.

- cAP ac (International) supports 2412-2484MHz and 5150MHz-5875MHz range (Specific frequency range can be limited by country regulations).

- cAP ac-US (USA) is factory locked for 2412-2462MHz, 5170-5250MHz and 5725-5835MHz frequencies. This lock can not be removed.

Wireless specifications

2.4 GHzTransmit (dBm)Receive Sensitivity
1MBit/s 26 -100
11MBit/s 26 -94
6MBit/s 26 -96
54MBit/s 23 -78
MCS0 26 -96
MCS7 22 -73
5 GHzTransmit (dBm)Receive Sensitivity
6MBit/s 26 -96
54MBit/s 21 -80
MCS0 26 -96
MCS7 20 -75
MCS9 18 -70

Ethernet test results

RBcAPGi-5acD2nD IPQ-4018 1G all port test
Mode Configuration 1518 byte 512 byte 64 byte
kpps Mbps kpps Mbps kpps Mbps
Bridging none (fast path) 162.5 1973.4 469.9 1924.7 1484.8 760.2
Bridging 25 bridge filter rules 162.1 1968.5 352.9 1445.5 359.2 183.9
Routing none (fast path) 162.5 1973.4 469.9 1924.7 1488 761.9
Routing 25 simple queues 162.5 1973.4 469.9 1924.7 506.3 259.2
Routing 25 ip filter rules 162.2 1969.8 240.8 986.3 242.9 124.4
  1. All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes
  3. Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out
  4. Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results

IPsec test results

RBcAPGi-5acD2nD IPQ-4018 IPsec throughput
Mode Configuration 1400 byte 512 byte 64 byte
kpps Mbps kpps Mbps kpps Mbps
Single tunnel AES-128-CBC + SHA1 37.9 424.5 59 241.7 61.6 31.5
256 tunnels AES-128-CBC + SHA1 36 403.2 38.5 157.7 39.8 20.4
256 tunnels AES-128-CBC + SHA256 36 403.2 38.5 157.7 39.8 20.4
256 tunnels AES-256-CBC + SHA1 34.4 385.3 37.9 155.2 39.8 20.4
256 tunnels AES-256-CBC + SHA256 34.4 385.3 37.9 155.2 39.8 20.4
  1. All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)
  2. Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1400 byte packet sizes
  3. Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results

Product Review


Add a review

Your email address will not be published.Required fields are marked *

Additional Information


Product code RBcAPGi-5acD2nD
Operating System RouterOS
License level 4
CPU IPQ-4018
CPU core count 4
Architecture ARM 32bit
CPU nominal frequency 716 MHz
Size of RAM 128M
10/100/1000 Ethernet ports 2
Wireless chip model IPQ-4018
Wireless standards 802.11b/g/n
Secondary wireless chip model IPQ-4018
Secondary wireless standards 802.11ac
Number of chains 2
Antenna gain DBI 2
Storage type Flash
Storage size 16M
Operating temperature range -40 to 50° C
Power Jack 1 (PoE-IN)
Supported input voltage 17-57 V
Max Power consumption 13W
PoE in 802.3af/at
PoE out Passive PoE up to 57V
Dimensions Round case: ⌀ 136 mm, height: 30 mm; Square case: 145 mm x 145 mm x 30 mm

Related Products

Recently viewed products